I have a $hit load of hardware with it.
I've actually built a semi cockpit for it.
Front panel for the FIP and MCP and side panel for the radio, knobs, etc.
And throttles.
Just finished doing some tests. (USB stuff)
I have - there about:
Saitek FFB stick.
Pedals. Cheap ones - as in they are plastic. I think CH brand. They work. Breaks, rudder.
Ch HOTAS for single engine stuff.
(And now it begins)
4 - Saitek FID
Go-Flight items:
1 - MCP
1 - TQ6
1 - ATC
2 - Radio panels
? - button bar (8 buttons)
? - switch bar (8 switches)
1 - 4 * knob and 8 * button bar
There are powered USB hubs to concentrate some of the devices nto 1 cable back to the PC
There is also a switched USB hug so I can turn off groups of devices if not needed.
The FIP and MCU are on the same HUB - well, not completely. 😞
I have a digitek 10 port powered HUB. If I put the 5 devices into it, 1 or 2of the FIP don't initialise on boot.
Tomorrow I will run FS for the first time and hope it gets it stuff together and I an then start testing/assigning the controls to the planes.
Oh, machine specs:
MSI Tomahawk 550
32 G ram
3.3 gig processor. AMD
1070 turbo GFX card.
(I think.)
21 x 9 monitor. (Curved)
Bought in 2020 for a lot of money.
Still does good. Not prefect, but it holds its own for what I do with it.